Altera USB Blaster User Manual

Page 15

Advertising
background image

Revision History for USB-Blaster Download

Cable User Guide

4

2015.05.04

UG-USB81204

Subscribe

Send Feedback

Date

Version

Changes

May 2015

2015.05.04

• Updated the document organization.

• Added new devices in the following sections:

Supported Devices and Host Systems and Power

Requirements.

• Updated the procedure on driver installation for

Windows.

• Revised the pin width of the female plug.

April 2009

2.5

• Updated “Supported Devices” section.

• Updated “Software Requirements”.

• Deleted handnote in “Installing the USB-Blaster

Driver on Windows Vista Systems”.

• Updated Table 2–1.

• Added a handnote in “Circuit Board Header

Connection”.

• Updated Table 2–5.

April 2008

2.4

• Added “Statement of China-RoHS Compliance”.

• Added Table 2–8.

• Added “Installing the USB-Blaster Driver on

Windows Vista Systems”.

May 2007

2.3

• Updated “Introduction”.

• Added warning note about USB-Blaster cable in

“Hardware Setup” section.

• Added information on Linux setup in “Installing

the USB-Blaster Driver on Linux” section.

• Added feetpara note on driver information just

before the “Setting Up the USB-Blaster Hardware

in the Quartus II Software” section.

• Updated USB-Blaster installation procedure for QII

6.1 (32-bit or 64-bit) in “Installing the USB-Blaster

Driver on Windows 2000 and Windows XP

Systems” section.

©

2015 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, ENPIRION, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are

trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as

trademarks or service marks are the property of their respective holders as described at

www.altera.com/common/legal.html

. Altera warrants performance

of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any

products and services at any time without notice. Altera assumes no responsibility or liability arising out of the application or use of any information,

product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device

specifications before relying on any published information and before placing orders for products or services.

ISO

9001:2008

Registered

www.altera.com

101 Innovation Drive, San Jose, CA 95134

Advertising