Subaru 2003 Baja - Manual (Page 140)

BAJA U.S.A..A2310BE–A
3-30
structures and make certain the ignition switch is in the “ON” position.
3. Press and hold the left button for 3 seconds then release, and the
compass will enter the calibration mode. “CAL” and direction will be
displayed.
4. Drive slowly in a circle until “CAL” disappears from the display
(about two or three circles). The compass is now calibrated.
5. Further calibration may be necessary should outside influences
cause the mirror to read inaccurately. You will know that this has oc-
curred if your compass begins to read in only limited directions.
Should you encounter this situation, return to step one of the above
procedure and recalibrate the mirror.
n Compass zone adjustment
1. The zone setting is factory preset to Zone 8. Refer to the “Com-
pass calibration zone” map at the end of this manual to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the right button for 3 seconds then release, and the
word “ZONE” will briefly appear and then the zone number will be dis-
played.
3. Press the right hand button repeatedly to cycle the display through
all possible zone settings. Stop cycling when the correct zone setting
for your location is displayed.
4. Releasing the button for 3 seconds will exit the zone setting mode.
J Outside mirrors
B Convex mirror (Passenger side)
WARNING
Objects look smaller in a convex mirror and farther away than
when viewed in a flat mirror. Do not use the convex mirror to
judge the distance of vehicles behind you when changing lanes.
Use the inside mirror (or glance backwards) to determine the
actual size and distance of objects that you view in convex mir-
ror.