Subaru 2003 Baja - Manual (Page 94)

BAJA U.S.A..A2310BE–A
2-16
a second time.
n Emergency disarming
If you cannot disarm the system using the transmitter (i.e. the trans-
mitter is lost, broken or the transmitter battery is too weak), you can
disarm the system without using the transmitter.
To disarm the system:
1. Unlock the door with the key and then open the door.
2. The alarm will sound.
3. Insert the key into the ignition switch and cycle it from “LOCK” to
“ON” three (3) times within 5 seconds.
B Sounding a panic alarm
To activate the alarm, keep the “LOCK/ARM” button pressed for more
than two seconds.
The horn will sound and the turn signal lights will flash.
To deactivate it, press the “LOCK/ARM” button or “UNLOCK/DISARM”
button.
Unless a button on the remote is pressed, the alarm will be deacti-
vated after approximately 30 seconds.
B Valet mode
When you choose the valet mode, the security system does not oper-
ate. In valet mode, the remote transmitter is used only for locking and
unlocking the doors and panic activation.
To enter the valet mode, open the driver’s door and keep the
“UNLOCK/DISARM” button depressed for more than two seconds.
The security system indicator light will continue to flash 2 times per
second indicating that the system is in the valet mode.
To exit valet mode, open the driver’s door and keep the “UNLOCK/
DISARM” button pressed for more than two seconds. The indicator
will stop flashing.
B Passive arming
When passive arming mode has been programmed by the dealer,
arming of the system is automatically accomplished without using the