Subaru 2003 Baja - Manual (Page 203)

BAJA U.S.A..A2310BE–A
6
Interior and exterior equipments
6-27
– CONTINUED –
HB6051BB
HB6052BB
1. Before placing the crossbar on the roof rails, make sure that the
T-30 torx
R head screw is fully loosened from each end support.
2. Spread the inner clamp and the end support as far apart as pos-
sible.
3. With the front direction arrow label on the top right side of the
crossbar pointing toward the front of the vehicle, carefully place the
crossbar across the top of the vehicle so that the crossbar end sup-
ports rest on the top of the roof rails 7 inches (180 mm) rearward in
the front radius of the roof rail.
4. Move the end support and inner clamp to hook under the end of
the roof rail on both sides and loosely assemble the T-30 torx
R head
screw with the tool provided into the threaded insert in the inner
clamp on each end of the crossbar.
NOTE
It may be necessary to start the inner clamp and end support at
the center of the roof rail for easier installation, then move the
crossbar forward. Use care not to cross-thread the screw in the
insert if it has been removed.