NISSAN 2012 Sentra - Manual (Page 210)

the battery of your iPod ா (if compatible) is
charged during the connection to the vehicle.
While connected to the vehicle, the iPod ா can
only be operated by the vehicle audio controls.
To disconnect the iPod ா from the vehicle, remove
the USB end of the cable from the USB jack on
the vehicle, then remove the cable from the
iPod
ா.
* iPod ா is a trademark of Apple Inc., registered in
the U.S. and other countries.
Compatibility
The following models are compatible:
● iPodா 5th Generation version 1.2.3
● iPodா Classic - version 1.1
● iPodா Touch - version 2.1*
● iPodா Nano - 1st generation version 1.3.1
● iPodா Nano - 2nd generation version 1.1.3
● iPodா Nano - 3rd generation version 1.0.2
● iPodா Nano - 4th generation version 1.0.4
● iPodா Nano - 5th generation version 1.0.1
* Some features of this iPod
ா may not be fully
functional.
Make sure that your iPod
ா firmware is updated to
the version indicated above.
Audio main operation
AUX button:
Place the ignition switch in the ACC or ON
position and press the AUX button repeatedly
until the iPod
ா mode is displayed on the screen.
If another audio source is playing and the iPod
ா is
connected, press the AUX button repeatedly to
switch to the iPod
ா mode.
If the vehicle audio system is turned off while the
iPod
ா is playing, the iPodா will start when the
VOL/ON-OFF control knob is pressed.
Interface:
The interface for iPod
ா operation shown on the
vehicle’s audio system display screen is similar to
the iPod
ா interface. Use the TUNE/SCROLL
knob and ENTER button to navigate the menus
on the screen. The iPod
ா MENU button on the
vehicle audio system is used to move up one level
in the iPod
ா menus.
Depending on the iPod ா model, the following
items may be available on the menu list screen.
For further information about each item, see the
iPod
ா Owner’s Manual.
● Playlists
● Artists
● Albums
● Songs
● Podcasts
● Genres
● Composers
● Audiobooks
● ShuffleSongs
SEEK/CAT buttons:
Press the SEEK/CAT buttons or to
skip backward or forward one track.
Press and hold the SEEK/CAT buttons
or
for 1.5 seconds while a track is playing
to reverse or fast forward the track being played.
The track plays at an increased speed while
reversing or fast forwarding. When the button is
released, the track returns to normal play speed.
RPT button:
Press the RPT button while a track is playing to
change the play pattern as follows:
1 TRK RPT
→ ALL RPT → RPT OFF
1 TRK RPT: the current track will be repeated.
Display screen, heater, air conditioner, audio and phone systems 4-57