Cruise control operations -19 – NISSAN 2008 Xterra User Manual

Page 199

Advertising
background image

● The SET indicator light may blink when the

cruise control main switch is turned ON

while

pushing

the

ACCEL/RES,

COAST/SET, or CANCEL switch (located

on the steering wheel). To properly set the

cruise control system, use the following pro-

cedures.

WARNING

Do not use the cruise control when driving

under the following conditions:
When it is not possible to keep the

vehicle at a set speed.

In heavy traffic or in traffic that varies in

speed.

On winding or hilly roads.
On slippery roads (rain, snow, ice, etc.).
In very windy areas.
Doing so could cause a loss of vehicle

control and result in an accident.

CAUTION

On manual transmission models, do not

shift into N (Neutral) without depressing

the clutch pedal when the cruise control is

set. Should this occur, depress the clutch

pedal and turn the main switch off imme-

diately. Failure to do so may cause engine

damage.

CRUISE CONTROL OPERATIONS

The cruise control allows driving at a speed be-

tween 25 - 89 MPH (40 - 144 km/h) without

keeping your foot on the accelerator pedal.
To turn on the cruise control, push the main

switch. The CRUISE indicator light in the instru-

ment panel comes on.
To set cruising speed, accelerate the vehicle to

the desired speed, push the COAST/SET switch

and release it. The SET indicator light in the

instrument panel comes on. Take your foot off the

accelerator pedal. Your vehicle maintains the set

speed.

To pass another vehicle, depress the ac-

celerator pedal. When you release the

pedal, the vehicle returns to the previously

set speed.

● The vehicle may not maintain the set speed

when going up or down steep hills. If this

happens, drive without the cruise control.

To cancel the preset speed, use one of the

following three methods.

● Push the CANCEL button; the SET indicator

light in the instrument panel goes out.

● Tap the brake pedal; the SET indicator light

goes out.

● Turn the main switch off. Both the CRUISE

indicator light and SET indicator light in the

instrument panel go out.

The cruise control is automatically canceled and

the SET light in the instrument panel goes out if:

● you depress the brake or clutch pedal while

pushing the ACCEL/RES or COAST/SET

switch. The preset speed is deleted from

memory.

● the vehicle slows down more than 8 MPH

(13 km/h) below the set speed.

● you depress the clutch pedal (manual trans-

mission), or move the shift selector lever to N

(Neutral) (automatic transmission).

Starting and driving

5-19

REVIEW COPY—

2008 Xterra (xtr)

Owners Manual—USA_English (nna)
06/26/07—debbie

Advertising