NISSAN 2008 Xterra User Manual

Page 94

Advertising
background image

4WD shift indicator light

(

model)

The light should turn off within 1 second after

turning the ignition switch to ON.
While the engine is running, the 4WD shift indi-

cator light will illuminate the position selected by

the 4WD shift switch.
The 4WD shift indicator light may blink
while shifting from one drive mode to the
other.

Front passenger air bag

status light

The front passenger air bag status light (

)

will be lit and the passenger front air bag will be

OFF depending on how the front passenger seat

is being used.
For front passenger air bag status light operation,

see “Front passenger air bag and status light” in

the “Safety — Seats, seat belts and supplemental

restraint system” section of this manual.

High beam indicator light

(blue)

This blue light comes on when the headlight high

beams are on and goes out when the low beams

are selected.

The high beam indicator light also comes on

when the passing signal is activated.

Hill descent control system on

indicator light (if so equipped)

When the ignition switch is turned ON, this light

comes on briefly and then turns off.
The light comes on when the hill descent control

system is activated.
If the hill descent control switch is on and the

indicator light blinks, the system is not engaged.
If the indicator light does not come on or blink

when the hill descent switch is on, the system

may not be functioning properly. Have the system

checked by a NISSAN dealer.
For additional information, see “Hill descent con-

trol switch” later in this section and “Hill descent

control system” in the “Starting and driving” sec-

tion of this manual.

Malfunction Indicator Light

(MIL)

If this indicator light comes on steady or blinks

while the engine is running, it may indicate a

potential emission control malfunction.
The Malfunction Indicator Light may also come

on steady if the fuel-filler cap is loose or missing,

or if the vehicle runs out of fuel. Check to make

sure the fuel-filler cap is installed and closed

tightly, and that the vehicle has at least 3 gallons

(11.4 liters) of fuel in the fuel tank.
After a few driving trips, the

light should

turn off if no other potential emission control

system malfunction exists.
If this indicator light comes on steady for 20

seconds and then blinks for 10 seconds when

the engine is not running, it indicates that the

vehicle is not ready for an emission control sys-

tem inspection/maintenance test. See “Readi-

ness for inspection/maintenance (I/M) test” in the

“Technical and consumer information” section of

this manual.
Operation

The Malfunction Indicator Light will come on in

one of two ways:

● Malfunction Indicator Light on steady — An

emission control system malfunction has

been detected. Check the fuel-filler cap. If

the fuel-filler cap is loose or missing, tighten

or install the cap and continue to drive the

vehicle. The

light should turn off after

a few driving trips. If the

light does not

turn off after a few driving trips, have the

vehicle inspected by a NISSAN dealer. You

2-18

Instruments and controls

REVIEW COPY—

2008 Xterra (xtr)

Owners Manual—USA_English (nna)
06/26/07—debbie

Advertising