Saturn 2010 VUE - Manual (Page 190)

7-24 Infotainment System
4. Continue entering digits until the
number to be dialed is complete.
After the whole number has
been entered, say “Dial”. The
system responds with “OK,
Dialing” and dials the number.
. If an unwanted number is
recognized by the system,
say “Clear” at any time to
clear the last number.
. To hear all of the numbers
recognized by the system,
say “Verify” at any time and
the system will repeat them.
Using the Call Command
1. Press and hold
J
/
0
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. Say “Call”. The system responds
with “Call using <phone name>.
Please say the name tag”
followed by a tone.
3. Say the name tag of the person
to call.
. If the system clearly
recognizes the name tag it
responds with “OK, calling,
<name tag>” and dials the
number.
. If the system is unsure it
recognizes the right name
tag, it confirms the name
tag followed by a tone.
If the name tag is correct,
say “Yes”. The system
responds with “OK, calling,
<name tag>” and dials the
number. If the name tag is
not correct, say “No”. The
system will ask for the
name tag to be re‐entered.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press and hold
J
/
0
for
two seconds. The system
responds with “Ready” followed
by a tone.
2. After the tone, say “Re‐dial”. The
system responds with “Re‐dial
using <phone name>” and dials
the last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
. Press J / 0 and begin speaking
to answer the call.
. Press − /
K
to ignore a call.