Agema AG7448 - Manual (Page 12)

9 AG-7448PL Series ToR Switch
(Figure 3-2: Installing the Switch in a Rack)
3. If installing a single switch only, go to Connecting to a Power Source.
4. If installing multiple switches, mount them in the rack, one below the other, in any order.
3.1.2 Horizontal Surface Mounting
The switch includes four pre-installed rubber feet for horizontal surface mounting.
To mount devices on a horizontal surface, follow these steps:
1. Attach the four adhesive feet to the bottom of the first switch.
(Figure 3-3: Attaching the Adhesive Feet)
2. Set the device on a flat horizontal surface near an AC power source, making sure there are
at least two inches of space on all sides for proper air flow.
3. If installing a single switch only, go to Connecting to a Power Source.
4. If installing multiple switches, attach four adhesive feet to each one, then place each device
squarely on top of the one below, in any order.