Atlona AT PRO2HD V1 - Manual (Page 3)

3
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Introduction
Extend HDMI and DVI (with HDMI to DVI adapter ex. AT-14040) sources up to 328ft at 1080p or
1920x1200. The Atlona HDMI to HDBaseT matrix switcher allows for effortless control of up to 32
devices through IR remote control, RS-232, 3rd party IR controllers and the front panel. With stereo
audio embedding combine stereo audio with DVI signals over category cable. To ensure all audio
passes through the matrix switcher supports all Lossy and Lossless formats of Dolby and DTS. The
AT-PRO2HD delivers the best quality available with pass through of up to 1080p, 1920x1200, 3D,
and Dolby TrueHD and DTS-HD Master audio signals.
Package Contents
Features
• 1 x HDBaseT to HDMI Matrix Switcher
• 1 x IR Receiver
• 9/17 x IR Emitter
• 2 x 24V/6.25A DC adaptor
• 2 x Power Cord
• 1 x Remote Control
• 1 x User Manual
• HDBaseT allows IR, RS-232, audio and visual signals to pass over a single CAT5e/6/7 cable.
• IR ports for zone dedicated control through IR remote control and 3rd party IR controllers.
• Programmable I/O memories, save multiple routes for faster switching to the most commonly
used configurations.
• EDID learning function for multiple video display EDIDs.
• Built in internal EDID mode provides 12 individual EDIDs to ensure compatibility
• Multiple control interfaces such as RS-232, IR, and the front panel.
• Dolby TrueHD and DTS-HD Master Audio pass through HDMI output interface.
• Compatible with DVI/D (with DVI/D to HDMI adapter such as AT14040), allowing DVI/D source
signal to be passed to displays.
• Audio embedding enabled with DVI/D sources. The built in 3.5mm audio import port allows
DVI/D audio to be passed through with the CAT5e/6/7 connection to HDMI displays.
• HDCP compliant
IR Receiver
IR Emitter
Before You Start
• Make sure when connecting the category cables a 568B termination method is used.
• Avoid using patch panels and wall plates during initial set up and testing of the matrix switcher.
• Make sure the matrix is connected to a component surge suppressor and line conditioner.
Note: Atlona’s warranty does not cover damage due to electrical disturbances. A component
surge suppressor and line conditioner are highly suggested especially in areas with electrical
storms.
• Be sure you’re using a mono to mono (2 conductor) 3.5mm IR cable when using IR output
control from 3rd party control boxes, stereo (3 conductor) 3.5mm cables are not compatible.