Atlona AT HDVS RX V2 - Manual (Page 6)

6
Menu Option Sub-Menu Option Adjust
OSD Position Left-Top, Right-Top, Right-Bottom, Left-Bottom, Center
Transparency 0 (transparent) to 15 (solid)
Info. Timer 5 to 100 seconds
Menu Timer 5 to 100 seconds
Info. Display Always On, Auto, or Always Off
Background Grey, Cyan, Magenta, or Yellow
Menu Back
Others In Auto Switch On or Off
Display HDCP Compliant, Noncompliant, Auto
Mirror-V On or Off
ASP Background Grey, Black
Display Mode DispSW AVon, DispSW AVSW, AV SW, Always On
Disp. Key Lock 0 to 15 seconds
Auto Disp. On On or Off
Auto Disp. Off On or Off
ProJSW Mode 5 to 300 (increases by 5)
Standby (min.) 0 to 15
Menu Back
Information Source
Name
Product
Sink
Model
Native 1
Native 2
F/W TX: RX:
Menu Back
System Reset No
Yes
Menu Back
Menu Exit
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
Note: Display Mode does a variety of changes, see below
DispSW AVon - Display switches on/off, source audio/video signal always on
DispSW AVSW - Display switches on/off, source audio/video signal switches on/off
AV SW - Display is always on, source audio/video signal switches on/off
Always On - Default, no function
Note: Must be in DispSW AVon or DispSW AVSW for RS-232 display control to work
ProJSW Mode: Used with a projector whose lamp cannot be turned on for up to 5 minutes after
being shut off. Keeps control in same state as projector. Match settings with lamp delay on
projector in 5 to 300 seconds. The LED will blink for the full amount of the delay time (ex. 40
seconds).
Standby (min.): Adjusts period of time before scaler goes into standby following loss of signal.
Default is 0 minutes (standby off)
Note: Standby must be active for Display Off to work - Standby time will set display off time as well.