Audio Solutions TVAM2-1 - Manual (Page 23)

24
Audio Settings
The Audio Mount Remote Control does not func on in a press and hold mode. You must depress the
bu on mul ple mes to increase or decrease the controlled func on.
• Press the BASS – bu on to reduce Bass,. When you have reached the midpoint or max limit, the LED
will turn RED.
• Press the BASS + bu on to increase Bass. When you have reached the midpoint or max limit, the LED
will turn RED.
• Press the TREB – bu on to reduce Treble. When you have reached the midpoint or max limit, the LED
will turn RED.
• Press the TREB + bu on to increase Treble. When you have reached the midpoint or max limit, the
LED will turn RED.
• Press the BAL-L to adjust the balance to the le . When you have reached the midpoint or max limit,
the LED will turn RED.
• Press the BAL-R to adjust the balance to the right. When you have reached the midpoint or max limit,
the LED will turn RED.
Push Button Reset
The reset bu on is only used in the event of a major system failure and should not be required under
normal opera on. If the system is no longer func oning properly, RESET will restore the system to factory
default se ngs.
1. Make sure the Unit is powered on and the Green, Blue or Red LED is on.
2. Push the RESET bu on and hold down un l the Green, Blue, or Red LED turns off and then the Green
LED turns on. If audio is being sent to the unit, you should be able to hear the audio through the unit.
The unit will reset the following user controls:
◦ Master Volume
◦ Bass and Treble to Mid points
◦ Input Selector to Op cal Input
◦ Hearing Impaired turned off
OPERATION