Brennenstuhl Remote Control Set RCS 2044 N Comfort - Manual (Page 15)

15
that purpose each switchable socket must be assigned the
frequency associated with one pair of buttons on the remote
control to allow each switchable socket to be controlled indi-
vidually.
Adjust the DIP switches with a suitable item, such as a small
screwdriver, by pushing the DIP switches either up or down.
Set the System Code on the Remote Control
1. Open the cover (10) of the battery compartment (13).
2. Set the system code of your choice using DIP switches (12)
1 to 5.
3. Close the battery compartment (13).
Set the System Code at the Switchable Socket
Back side of switchable socket
1. Unscrew the screw (16) and the cover (18) on the rear of
the switch socket using a suitable Phillips head screwdriver.
2. Gently lift up the cover (18) over the screw opening (17) and
swivel to the outside.
3. Using the DIP switches (14) 1 to 5, set the same system
code as on the remote control.
Operating instructions RCS 2044 N
096812 BA_Funkschaltset RCS 2044 N 24.09.14 13:45 Seite 15