CIRCUTOR REC3 Series - Manual (Page 11)

3�- UNIT INSTALLATION
3.1.- PRIOR RECOMMENDATIONS
In order to use the unit safely, it is critical that those who handle it follow the
safety measures set out in the standards of the country where it is being used,
use the necessary personal protective equipment and pay attention to the vari-
ous warnings indicated in this instruction manual.
The REC 3 unit must be installed by authorised and qualified staff.
Also, it is critical to keep the cables in perfect condition in order to avoid accidents, personal
injury and damage to installations.
The manufacturer of the unit is not responsible for any damages resulting from failure by the
user or installer to heed the warnings and/or recommendations set out in this manual, nor
for damages resulting from the use of non-original products or accessories or those made by
other manufacturers.
If you detect any operational faults in the unit or in its protection system, remove the unit from
service.
This unit has been designed for easy replacement in case of malfunction.
Disable the automatic reclosing function and disconnect the main protection
device before handling active parts.
Please contact the after-sales service if you suspect that there is an operational
fault in the unit.
3.2.- INSTALLATION
Do not use the unit until it is fully installed.
The REC 3 is a unit specifically designed to be installed in electric panels or enclosures, with
DIN rail fixing elements (IEC 60715).
To install the unit on a DIN rail ( Figure 5) :
1�- Place the unit at the top of the DIN rail.
2�- Swing the REC 3 downwards until it is secured to the lower section of the DIN rail.
3�- Make sure that it has been secured on the rail.
11 Instruction Manual
REC 3 - REC 3C