CONTA-CLIP EMS-2-Plotter-System - Manual (Page 9)

Placing the fixtures on the Plotter
There are eight pin stops on the plotting area where up to four different fixtures can be
loaded. Different fixtures are available depending on the size of the marking elements.
They can occupy one, two or four segments on the plotting area.
Please note:
When fitting fixtures or inserting marking elements into the fixtures it is possible for the
writing arm to be moved out of place, altering the calibration.
If the writing arm is moved, press the 'stop/view' key twice in succession to recalibrate
the system.
Different size fixtures:
Placing the elements in the fixtures
Choose the appropriate fixture for the elements to be labelled and insert the elements
carefully into the fixture. You can also add the elements first and then place the
fixtures in the plotter.
1 segment 2 segments 4 segments
8