CUE touchCUE-V i - Manual (Page 7)

4.2. Rear Panel of the touchCUE-V /i
Power Supply Connector PWR IN
This connector allows you to connect touchCUE-V/i to the external power 24V/ 15W with the supplied AC
CUEadapter.
Important note
After switching the power supply off a minimum pause of 5 seconds is necessary before switching the power
supply of the touch panel unit on again.
CUEwire Connector
The connector marked CUEwire is used for the connection between touchCUE-C /i and the controllers.
Video Input Connectors
2x Composite video input on BNC connector: VIDEO1
VIDEO2
1x S-video input on two BNC connectors: S-VIDEO Y (Intensity, Luminance)
S-VIDEO C (Colour, Chrominance)
10/100 BaseT LAN Connector
The 10/100 BaseT LAN is a standard network connection 10/100 BaseT LAN using RJ-45 connector. There
is no auto sense, which means it does not recognize straight through cable to cross-over cable. For the
direct PC connection it is necessary to use cross-over cable; for the connection to Ethernet switch straight
through cable. The length of the Ethernet cable connecting touch panel to the network must not exceed 100
meters.
User Manual touchCUE-V /i
www.cuesystem.com
Page 7 of 27