Flip image output – Datapath VQS-01 User Manual
Page 16
16 24/02/2011
70Hz
72Hz
75Hz
85Hz
Flip Image Output
The Flip Image Output option enables the user to display the image as a flipped image i.e.
upside down.
To operate the Flip Image Output mode:
Use the Select
button and navigate through the settings until the “A” or “D” LED
(depending on if yo
u have analog or digital monitors connected) is lit, the “C” LED is
lit but the “B” LED is not lit.
Continue to press the Select button until the required Output has been located. The
table below illustrates which LED’s should be displayed for which output.
Use the + and - buttons to flip the image.
Note:
For illustration purposes the LED panel in the table is indicating that a DVI source is
connected i.e. the “D” LED is on. If a VGA source is connected the “A” LED would be
illuminated:
Selecting
this series of LED’s and
using the + and - buttons will flip the
image displayed in the top left
screen (Output 1)