Datapath VQS-01 - Manual (Page 19)

19 24/02/2011
Resetting the VQS-01
Factory default Settings
The VQS-01 is shipped with a default setting for all modes and options. There may at
sometime be a requirement to restore the modes and options to the default settings.
To re-set all the modes and options to the factory default settings:

Press the Select, the + and the Save buttons simultaneously
 The unit will then illuminate all 8 LED’s to confirm the default settings.

Press Save to confirm or Select to cancel.
To reset a particular mode or adjustment to the factory default setting the following steps
should be taken:

Navigate to the required mode that you wish to reset, i.e brightness or vertical
position for example.

Press the + and the - button simultaneously.
 The “A” or “D” and “B”, “C”, “E”, “F”, “G” and “H” will all be lit temporarily to indicate
the value has been reset.

Press Save to confirm.
The setting for that particular mode will now be restored to the factory default.