One Systems POPS 15a - Manual (Page 12)

AC Mains panel connector
NOTE: ALWAYS turn off the AC mains power BEFORE attempting to disconnect
the AC mains cable from POPS15a’s amplifier module!
To disconnect the cable end of the AC mains connector pull back on the collar of
the cable end connector in the direction shown on the connector. While pulling
back on the collar pull the cable end connector away from the chassis connector.
It is necessary to physically support the enclosure while disconnecting the AC
Mains connector to avoid pulling the enclosure over if the enclosure is not
securely mounted.
The AC mains supply end of the cable is shown in the image below (Image 1)
Once the AC mains cable is connected to POPS15a’s amplifier, the other end of
the AC mains cable may be connected to the AC mains supply. This end of the
AC mains cable is a standard connector and MUST be connected in an area that
is DRY. The figure below shows both ends of the AC mains cable. The connector
on the right side of this photo is the IP 68-rated cable end that should be
connected to the AC mains input on POPS15a’s amplifier module. The connector
on the left side of this photo is connected to the AC mains supply located in a dry
area.
NOTE: The configuration of the connector on the left side will vary depending on
which region of the world POPS15a is used in.