One Systems POPS 15a - Manual (Page 17)

WARNING: DO NOT SUBSTITUTE “NORMAL” XLR CABLE CONNECTORS.
FAILURE TO USE NEUTRIK NC3FXX-HD-D CONNECTORS WILL
COMPROMISE THE WATER / MOISTURE RATING OF POPS15a AND MAY
RESULT IN UNSAFE CONDITIONS. NEUTRIK NC3FXX-HD-D CONNECTORS
MUST BE USED FOR ALL CONNECTIONS ON POPS15a.
RIGGING AND SUSPENSION OF POPS15a
POPS15a features 7 x M10 (metric) stainless steel rigging points. The enclosure
may be suspended for temporary installations. There are four M10 points on the
top of the enclosure, two on the bottom of the enclosure and a single “pull up”
point on the rear, bottom portion of the enclosure.
WARNING: The single M10 point on the rear of the enclosure is NOT intended
for suspension of the enclosure and should NOT be used for suspension. The
M10 point on the rear of the enclosure is for pull up and aiming ONLY!
The M10 rigging points are shown in the image below.
Rigging Points Shown Above
DO NOT USE THE BACK POINT FOR SUSPENSION
THIS POINT IS FOR “PULL UP” ONLY!