Presentation Switchers PS510 - Manual (Page 11)

Page 11 Series 500 Installation Guide
Connecting Control Devices Connecting Control Devices
In addi on to the standard front panel controller, the Series 500 provides addi onal control
methods. Serial (RS-232) and Ethernet provides connec on to third-party controllers such as
Crestron and AMX.
Crestron or AMX Control Systems Crestron or AMX Control Systems
Connec on to a 3rd party (AMX/Crestron etc) control system can be accomplished using RS232
or Ethernet. Se ngs can be adjusted using the Confi gura on U lity discussed in more detail
later in this guide.
The default baud rate for the serial port is 115200.
Display Control Display Control
The PS510 has a simple control system for controlling a display device (LCD, Plasma, or Projec-
tor). The serial port is connected directly to the display device. Codes are uploaded and stored
in the PS510 using the PS500 Display Control U lity. When the system is shutdown and a input
source is selected the projector is sent a “power on” command. When the signal is shut down
and signal is lost, the PS510 issues a “power down” command.
Uploading commands to the Series 500 is described in more detail later in this guide.