Thor 4 Ch HD-SDI Encoder w/ CC & AC/3 User Manual
Page 11
H-2/4HD-EM(S/H)
3.2 Initial Status
Switch on the device and after a few seconds’ initialization, it presents start-up pictures as
shown below:
H-HD-EM: Module name and number
P1: Program 1; P2: Program 2; P3: Program 3; P4: Program 4
X.XX Mbps: indicate the current encoding bit rate of the corresponding channel.
3.3 General Settings for Main Menu
Press “Lock” key on the front panel to enter the main menu. The LCD will display the
following pages where user can configure the parameters for the device:
User can press UP/DOWN buttons to specify menu item, and then press ENTER to
enter the submenus as below:
1)
Status
Start up…
Start OK…
H-HD-EM HD ENCODER
P1:X.XXMbps P2: X.XXMbps
1 Alarm Status
2 Encode Setting
3 Modulate Setting
4 IP Output Setting
5 Network Setting
6 Saving Config
7 Loading Config
8 Version
1.1 Alarm
1.2 Uptime