WaveWare Alert Utility - Manual (Page 25)

Step 2 – Configuration – Output – LED Message Board(s)
To use LED Message Board(s) for an Output, you will need to Configure the Message Board(s) that will be used
with this Application. To Add a LED Message Board, Place a Check Mark next to “ LED Message Board(s) ” and
then Click on the “ Configure Message Board(s) ” Button. See Fig. 35
Fig. 35 LED Message Boards
Click on the “Configure Message Boards” Button
In the “Configure Message Board(s)” screen, you have these options:
There are Three Fields for Configuration for use with a LED Message Board(s):
 Output Options
 Message Display Configuration
 Maintenance
Output Options:
For Reference, See Fig. 36

To use as a “ Wired Connection ”
o Choose the Com Port that the LED Message Board is attached to and Configure the Port

To use as a “ Wireless Connection ” using a Paging Data Receiver, for Delivery of the Message to the Board(s)
o This Option allows you to Send a Message to the Paging Data Receiver (PDR) that is attached to the
LED Message board(s), via the Paging System

To use “ Message Routing ”
o This Option allows you to Associate a PIN Number to a Sign’s Address
Wired - Configure Com Port PDR–Configure PIN– Message Routing
Table
Fig. 36 Output Options
25