Argox A Series - Manual (Page 35)

A Series User’s Manual
69
13. After driver installation is complete, click "Close".
The driver should now be installed.
Installed printer Argox A-2240 PPLB
A Series User’s Manual
70
Troubleshooting
Normally, when the printer is in not working properly, the
"Power" LED blinks continuously, and printing and
communication between the host and printer stops.
LED Diagnosis
If the Power and Ready LEDs are blinking, it means you may
have a problem. To understand the problem, please check the
Power and Ready LEDs and refer to the following solutions:
LED Indicators: Power and Ready LEDs blink at the same
tempo
Power LED Ready LED
ON
ON
OFF OFF
Possible Problems Solutions Remarks
Miss-detect gap
Check the label path
Check the label sensor If you use a
continuous label roll
and run under
Windows, select the
continuous media.
Label stock out Supply the label roll
Label stock not
installed Install the label roll
Label jam Recover the jam