Auto-Zone Control Systems EZ-Zone to Auto-Zone Upgrade Guide (Version 01C) - Manual (Page 15)

EZ Zone/Auto-Zone
Upgrade 15
Lighting Panel Controller
Adds building lighting control capability to the Auto-
Zone System. The Lighting Panel Controller provides
up to (7) Independent time schedules and light levels
for control of up to (7) lighting circuits. The Lighting
Panel Controller relay outputs can be set for on/off re-
lay or pulsed relay control depending on the lighting
system control contactor requirements. Pushbutton over-
ride is available for each lighting circuit by connecting
a momentary pushbutton to the Lighting Panel Con-
troller board. The Lighting Panel Controller can be used with the Auto
Zone Plus System only. The System Manager cannot
be used to program or monitor the Lighting Panel Con-
troller. Light Panel Controllers require that a personal
computer which has the ZoneView computer front end
software installed be used for all programming and
monitoring.
Optimal Start Scheduler
Provides expanded scheduling capabilities beyond those
incorporated with the standard Auto-Zone controllers.
The Optimal Start Scheduler provides for optimal
Start/Stop and up to (7) independent schedules with 2
Start/Stop events per day and (14) Start/Stop holiday
events per schedule. The Optimal Start Scheduler can be used with the Auto
Zone Plus System only. The System Manager cannot
be used to program or monitor the Optimal Start Sched-
uler Controller. This controller requires that a personal
computer which has the ZoneView computer front end
software installed be used for all programming and
monitoring.
Wetbulb Module
Provides wetbulb temperature monitoring for control
of all economizer equipped units on the Auto-Zone
system. The Wetbulb Module includes an Outside Air
Humidity Sensor for measuring outside air relative
humidity and utilizes the installed Outdoor Air Sensor
on the Auto-Zone System to calculate the wetbulb
temperature. This temperature is used by the economizer
control portion of the unit controller to provide accurate
economizer operation. The Wetbulb Module can be used
with the Auto-Zone Basic and Plus Zone Systems. The
Wetbulb Module can be monitored and programmed
from either the System Manager or from a personal
computer which has the ZoneView computer front end
software installed.
Accessories
WattMaster offers a complete line of accessories for
your Auto-Zone system. For part ordering information
and a complete list of accessories please see the Auto-
Zone Product List Pricing manual and the Auto-Zone
Replacement Parts List Pricing Catalogs. Following is
a brief list of some of the accessories that are offered
for the Auto-Zone system.
• Remote Link - 14,400 baud modem for
remote access to any Auto-Zone system
• CommLink II - Required to connect the
Auto Zone Basic system to a personal
computer
• Round Air Dampers - Air damper with a
Zone Controller and actuator mounted in a
control enclosure. Available in pressure
dependent and pressure independent models.
Available in round duct sizes of 6”, 8”, 10”,
12”, 14” and 16” diameter.
• Rectangular Air Dampers - Rectangular,
aluminum frame opposed blade dampers.
Available in rectangular duct sizes from 8” x
8” to 24” x 36” in 2” increments of height and
width
• Rectangular Air Damper Kit - Zone
Controller and actuator mounted in a control
enclosure for use with Rectangular Air
Dampers
• ZoneView Computer Front End Software
Free when ordered with an EZ Zone to Auto-
Zone upgrade