Avalon Firestyles 700 B-Vent-1994 User Manual
Page 30
P
AGE
30
O
PTIONAL
E
QUIPMENT
(C
ONTINUED
)
Surround Panels
(Part number is listed below)
The panels for the 700 are purchased separately from the heater and are available in three sizes.
The table below details the finished size of the panels once they are installed. Make sure to
purchase the panels that will cover the fireplace opening in both height and width.
Size of Panels
Height
Width
Part #
8"
28"
40"
99300259
10"
30"
44"
99300260
12"
32"
48"
99300261
The panels should be installed after the insert is in place and connected to the vent.
1.
Remove the two button plugs from each side of the insert with a screwdriver (see
the illustration below).
2.
Using a 5/16" nutdriver, screw the thread-cutting screws into the four holes
exposed by removing the button plugs. The holes are now pre-threaded, remove
the screws.
3.
Place one of the side panels against the side of the insert, lining up the slots in the
panel with the threaded holes in the side of the insert. Attach the panel with the
thread-cutting screws, leaving the screws loose enough to adjust the side panel.
Repeat for the other side.
4.
Slide the top panel onto the offset on top of the side panels. The top panel has
joggle clips that hold the top panel in place against the side panels. The best way
to insert the top panel is to hold it at an angle and insert one side first and
gradually lower it until the opposite side is inserted. Adjust the top panel so its
edges are flush with the side edges of the side panels.
5.
Adjust the position of the side panels so they are: 1) flush with the bottom of the
insert; 2) both the same distance back from the front of the insert; 3) perpendicular
to the floor. Then tighten the screws to secure the panels.
NOTE:
Discard the insulation that comes with the surround panels (for wood stoves only).
The panels must not form an air-tight seal against the fireplace.
Side Panel
Remove the button plugs located here. Use the
thread cutting screws to attach the side panel.
Use two thread
cutting screws
to attach each
side panel.
The joggle clips on the top
panel slide over the offset
portion on top of the side
panels.
Side Panel
Top Panel