Avalon Firestyles GreenStart Igniter 2 for Freestanding Stoves - Manual (Page 6)

GreenStart Igniter 2 for Freestanding Stoves
Installation Instructions
(SKU 94400953)
Page 6 of 27 17601769.docx— 12/11/13 © Travis Industries, Inc.
Attaching the Compressor Assembly to the Stove
Answer, Olympic, Rainier Only
NOTE: See the Addendum for Liberty igniter attachment.
1. Install the bolts into the rear heat shield on the stove:
• Answer: Use four (4) ¼-20x1-3/4” bolts.
• Olympic: Use four (4) ¼-20x1-3/4” bolts with ½” washers.
• Rainier: Use four (4) ¼-20x2-3/4” bolts into the rear heat shield on the stove.
NOTE: A few bolt threads should protrude from the stove.
NOTE: The washers are used as spacers, and are inserted between the stove and the compressor
assembly.
2. Hang the compressor assembly on the rear of the stove, as shown below. The 4 slots fit over the 4
bolts.
3. Tighten the bolts to secure the compressor assembly to the stove. A ratchet with an extension may
help with this task.
NOTE: Do not over-tighten these bolts.
NOTE: An extra outlet may be used with the Answer, Olympic and Rainier stoves; see page 3.
This completes attaching the compressor assembly to the Answer, Olympic, and Rainier.