Avalon Firestyles GreenStart Igniter 2 for Freestanding Stoves - Manual (Page 7)

GreenStart Igniter 2 for Freestanding Stoves
Installation Instructions
(SKU 94400953)
Page 7 of 27 17601769.docx— 12/11/13 © Travis Industries, Inc.
Liberty Only
1. Install the bolts into the rear heat shield on the stove using four (4) ¼-20x1-3/4” bolts with the four
(4) large grommets.
Note how the grommet is placed so that the notch is at the outer edge of the bolt.
2. Tighten the bolts until the grommets contact the heat shield.
NOTE: Do not over-tighten these bolts.
3. Hang the compressor assembly on the rear of the stove, as shown below. The 4 slots fit over the
4 bolts in the grommet notch (see below).
NOTE: An extra outlet may be used with the Liberty stove; see page 3.
Grommet Notch