Avery Dennison 6037 Rev. AA 3/04 Programmer Manual - Manual (Page 96)

4-54 ROM-DOS Internal Commands
N U M L O C K
CONFIG.SYS Command
The NUMLOCK command sets the Num Lock key on the keyboard to ON
or OFF when your computer starts.
Syntax
NUMLOCK=[on|off]
Remarks
Selecting ON designates that the Num Lock key is set to on when DOS
boots. Selecting OFF designates that the Num Lock is off
when DOS
boots. In either case, you still have the ability to manually turn the Num
Lock key on and off after booting with the NUMLOCK command.
Example
NUMLOCK=on
Sets the Num Lock key to on when the system boots.