Baby Lock Enlighten (BLE3ATW-2) Instruction and Reference Guide - Manual (Page 13)

1. With the presser foot in the up position, open the front cover and move the threading lever into the thread-
ing position (fig. A page 10).
2. Place the thread cone or spool on the second spool pin from the right. Slip the thread into the telescop-
ic antenna thread guide "A" directly above the spool, snap into the thread guide "B" at the top of the front
of the machine, through the slot on the front cover (fig. C).
3. Pull 18 inches (45cm) of thread through guide "C". Insert the end of the thread into the threading port "U",
about 1/2 inch (1.2cm). Use tweezers, if necessary, to insert the thread end more easily (fig. D).
4. Push the threading button (fig. D). If the thread does not go through the upper looper eye with one push,
press the looper threading button again until it does, and leave thread hanging loose.
5. Set the threading lever to serging position.
*Be sure at least 1/2" of thread is inserted into the threading port.
S
E
R
G
E
R
S
E
T
U
P
11
Upper Looper
Push To Thread Button
D
C
2
2
3
B
B
A
1
C
1/2"
(1.2cm)
18"(40cm
)