Baby Lock Enlighten (BLE3ATW-2) Instruction and Reference Guide - Manual (Page 14)

S
E
R
G
E
R
S
E
T
U
P
12
Right Needle
1 A
B
C
D,4
2
3
G,7
2
B
E,5
F,6
Handwheel
A
1. With the presser foot up position and the machine engaded in the threading position (page 10, fig.
A), set the needle threader selector on "R" to thread the right needle (page 13, fig. A ).
Note: Be sure to push the needle threader selector all the way to "R".
2. Place the thread on the second spool pin from the left on the thread stand (illustrated below).
Thread needle thread guides 1 and 2, through the groove on the front of the machine and through
guides 3, 4, 5, 6 and 7. Pull a 6-inch (15 cm) length of thread through guide 7.
3. Lower the presser foot to engage the tensions.
4. Manually insert thread into the eye of the right needle or follow needle threader instructions on page
13.
5. Continue pulling the thread through the needle eye. Place the thread under the presser foot and to
the left.
Note:The Enlighten must be in threading position when using the needle threader unless otherwise
indicated. This is also a safety feature when threading the machine, as the machine cannot sew
while in the threading position.