Baby Lock Enlighten (BLE3ATW-2) Instruction and Reference Guide - Manual (Page 25)

The rolled edge setting is used to achieve the narrowest stitch possible (1.5mm) on your Baby Lock serg-
er. The stitch is suitable for seaming sheer and lightweight fabrics and for edging and hemming lightweight
fabrics.
R
O
L
L
E
D
E
D
G
I
N
G
23
Rolled Edging
3-Thread Rolled Edge
With the stitch selector set on "D", a narrow hem will become a rolled edge. The fabric edge rolls around
the stitch finger. The upper looper wraps the fabric edge while the lower looper thread is nearly invisible on
the back side of the stitch formation.
Remove the left needle and thread. Clear the stitch fingers. Turn the stitch length adjusting dial counter-
clockwise into the rolled hem range at 0.75-4.0R setting (fig. A). Set the stitch width dial to 3.5 "M" (fig. B).
For a 3-thread rolled edge, move the stitch selector lever to "D" and follow the suggested settings and
threading diagram below.
B
A
NEEDLES
right
LENGTH
0.75-4.0R
WIDTH
3.5
STITCH
SELECTOR
D
WAVE
SELECTOR
OVERLOCK