Baumatic BRCF1855SL - Manual (Page 19)

Replacing the light bulb
19
T BULB.
WARNING: PLEASE ENSURE THAT YOUR APPLIANCE
IS DISCONNECTED FROM YOUR MAINS SUPPLY
BEFORE ATTEMPTING TO REPLACE THE LIGH
o
Remove all adjustable shelves for your safety before changing
the light bulb.
o
Hold and gently lift up the light bulb cover to allow access to the
bulb.
o
Remove the old bulb by unscrewing it in an anti-clockwise
direction.
o
Replace with a new bulb of the same type (15W) by screwing it
in a clockwise direction. Take care to ensure that the bulb is fully
secured in the bulb holder.
o
Refit the light bulb cover and reconnect your appliance to the
mains supply and turn on.
The defrost drain hole
o
Defrosting occurs automatically in the refrigerator section during
operation. The defrost water is collected by the evaporating tray
and evaporates automatically.
o
The drain hole should be cleaned periodically with a drain hole
cleaner. This will prevent water from collecting in the bottom of
the refrigerator, instead of flowing down the defrost drainage
channel and drain hole.
o
IMPORTANT: Please note that the drain hole cleaner should not
be left in position permanently. Otherwise this may prevent the
defrost water from entering the drain hole.
o
You can also pour a small amount of water down the drain hole
to clean the defrost drainage channel.
o
You should be careful to make sure that food packages do not
touch the rear wall of the appliance, as this can interrupt the
automatic defrosting process and deflect water into the base of
the refrigerator section.
o
Use a solution of bicarbonate of soda and lukewarm water to
clean the evaporating tray.