Belshaw Adamatic Snack Master Snack Food Frying System - Manual (Page 24)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
2 MN-1013EN Snack Master TS
Figure 1-1. Donut Robot Mark II.
Unpacking the Fryer
The Snack Master may come with a optional
table and EZ Melt Shortening Filter.To unpack
the equipement, first transport all the pieces to
the work area.:
1. Remove all crating and packing material
from the equipment.
2. Remove the cover and the conveyors from
the fryer.
3. Disconnect the control box power cord
5. Remove the clevis pins that hold the heater
head in place, and lift the heater head out of
the fryer.
6. Coil the power cord and carry the heater
head to the workstation.
7. Move the fryer case and kettle to the
workstation.
Initial Cleaning
Thoroughly clean your Snack Master before
using it. Remove all packing materials. Use
household dishwashing detergent. Do not use
strong alkali cleaners such as lye, soda ash, or
trisodium phosphate. Thoroughly dry and
lubricate parts to prevent rusting.
Refer to the Cleaning section in the Operator's
Manual for detailed cleaning instructions.
WARNING
To avoid electrocution or damaging the
machine, never allow water, steam,
cleaning solution, or other liquid to enter
the cutter head or heater head assemblies.
WARNING
Never let water and hot shortening come in
contact. Moisture causes hot shortening to
spatter, which may cause serious injury.
Prior to use, make sure any parts you have
washed are dry.
After cleaning, assemble the fryer and cutter as
explained below.
Assembling the Fryer
1. If the optional table is used, place the table
in place and level.
2. Place the fryer case the table or on a flat,
stationary surface.
2. Screw the fryer’s legs in as far as they will
go.
3. Set the kettle into the fryer case. The end of
the kettle that has the locating pin must be
placed at the outfeed end of the fryer case.
The lip of the kettle should fit securely over
the edge of the case.
4. Install the heater head assembly as follows:
a. Align the holes in the heater head end
caps with the holes in the heater head
mounting brackets.
b. Slide the clevis pins through the holes so
that the pinheads are on the outsides.
c. Insert the hairpin clips into the holes in
the clevis pins.
5. Lower the heater head assembly into
position so the thermostat bulb bracket rests
on or very near the bottom of the kettle.
6. Install the lower conveyor assembly as
follows:
a. Hold the conveyor at an angle and slide
the conveyor drive coupling over the
main drive shaft coupling. The conveyor