Chapter 5, Dip switch – Bematech KB-1800 User Manual
Page 19
19
U
S
e
R
’S
MANU
A
l KB
-1800
·
R
evision 1.3
Chapter 5
Dip Switch
One set of dip switches is mounted in the control board of the KB-1800. To access these dip switches, please do
as follows:
• Turn off the printer
• Remove the paper from the mechanism
• Remove the screws that hold the cover of the control board
• Using the tables below, change the configuration of the dip switches
• Mount the cover of the control board and fasten the screws back
Dip Switch
Function
1
Baud Rate
On: 115200 bps *****
Off: 9600 bps *
2
PNE
On: activated **
Off: not activated
3
Reserved
Must be in off position
4
Stop Bits
On: 1 stop bit *
Off: 2 stop bits
5
Character leght
On: 7 bits
Off: 8 bits *
6
Parity Select
On: Odd
Off: even *
7
Parity
On: not used *
Off: used
8
Presenter
On: activated ***
Off: not activated ****
*
Default
**
ON - Default or :
After esc m: PNe sensor is returned in status bit (serial or USB) or Pe line (Parallel)
After esc l: Presenter sensor is returned in status bit (serial or USB) or Pe line (Parallel)
OFF - Default or after esc m: always return paper ok
After esc l: always return paper ok
***
Default for printers with presenter
****
Default for printers without presenter
*****
If you set 115200bps for baud rate, you must change the dip switch 4 to OFF position, using 2
stop bits for your setup. The spooler driver is setup for 2 stop bits