Bematech KC-4112 Rev.1.1 - Manual (Page 18)

User’s Manual
18
Chapter 5
Dip Switch Dip Switch Dip Switch Dip Switch Dip Switch
One set of dip switches are mounted in the control board of the KC-4112. To access these dip switches, please
do as follows:
• Turn off the printer.
• Remove the paper from the mechanism.
• Remove the two screws that hold the cover of the control board.
• Using the tables below, change the configuration of the dip switches.
• Mount the cover of the control board and fasten both screws back.
Dip Switch Function
1 Reserved
2 PNE On: activated
Off: not activated
3 Baud Rate On: 19200 bps
Off: 9600 bps
4 Stop Bits On: 1 stop bit
Off: 2 stop bits
5 Character On: 7 bits
lenght Off: 8 bits
6 Parity Select On: Odd
Off: Even
7 Parity On: not used
Off: used
8 Presenter On: activated
Off: not activated