BUG-O Systems CWP-5 - Manual (Page 5)

5
INTRODUCTION
The CWP-5 Circle Welder is designed for circular single or multi-pass welding of couplings on sprinkler
pipe utilizing MIG or FLUX CORED process, with gas shielding. For 1-12 in. (25.4-304.8 mm) diameter
welds. The CWP-5 can accommodate couplings in both on-center and hillside positions.
FEATURES
• Amperage & wire speed control
• Wire feeder with one set of drive rolls
• 1/12 HP P.M. motor and rotational speed control
• 300 AMP Gun & cable assembly
• Gas shielding kit with 120 VAC solenoid valve
• 5/8" (16 mm) gas cup
• Burn back control
• 50 ft. (15 m) power cable
• 50 ft. (15 m) gas shielding hose
• 50 ft. (15 m) weld cable
• Quick disconnects for all cables
• Weld contact switch
• Cold wire inch switch
• Wire direction switch
• Pre and post flow controls
• Wire reel adaptor for 30 lb. (14 kg) spools
• Adjustable vertical and horizontal torch positioning system
• Microprocessor controlled rise and fall with 5" (125 mm) of travel
• Brushes and collector rings for welding current, rated at 300 AMPS 100% duty cycle
• Brushes and collector rings for all controls, eliminate cable and hose wrap