Campomatic C964XRSIFSCN - Manual (Page 31)

31
�����
� � � � �
�� �
� � � � �
�� � ��
����� ��
� � � � �
�� � �� ��
����� �� ����� �
� � � � �
�� �� ��
����� ����� ����� �����
25
ELECTRICAL CONNECTION
The electrical connection must be carried out in
accordance with the current standards and laws
in force.
Before connecting check that:
• The system and electrical sockets amperage is
adequate for the appliance maximum power (see
data label affixed on the back of the cooker).
• The socket or system has an effective earth
connection in accordance with current standards
and prescriptions of the law. All responsibility is
disclaimed if this is not complied with.
• The plug and socket or the multipolar switch must
be accessible after installation of the appliance.
• If the appliance has no power cable, connect one
with a suitable cross section to the terminal board
(see paragraph «CONNECTING THE POWER
CABLE»).
When connecting to the mains with a socket:
• Fit to the power cable (if without) a standardized
plug, suitable for the load which is indicated on the
data label. Connect the wires making sure they
correspond as shown below, and remember that
the earth wire must be longer than the phase
wires:
letter L (phase) = brown wire
letter N (neutral) = blue wire
symbol (earth) = green/yellow wire
• The power cable must be laid so that no parts of it
ever reach a temperature of 75 °C.
• For connecting do not use, adapters or shunts
as they could cause false contacts resulting in
hazardous overheating.
When connecting directly to the mains:
• Install a multipolar switch that can withstand the
appliance load, with a minimum opening between
the contacts of 3 mm.
• Remember that the earth wire must not be cut out
by the switch.
INSTRUCTIONS FOR THE INSTALLER
CONNECTING THE POWER CABLE
The all-electric cookers and some combi versions
leave the factory ready for single-phase power, butt
they can, with due modifications, be powered by three
phase systems by following these instructions:
• Remove the rear panel from the cooker.
• Move the connecting plates in the terminal board
according to the type of connection you want,
following the diagram in fig. 25. You will also find
this diagram affixed to the back of the cooker.
• Connect the power cable, whose cross section
must be suitable (see table on page 27), keeping
the earth wire longer than the phase wires.
• Secure the cable in the clamp and - fit the rear panel
in place.