Campomatic C964XRSIFSCN - Manual (Page 36)

36
��
��
��
��
�
�
��
�
MAINTENANCE
Prior to any maintenance work or changing parts, disconnect the appliance from the gas and electricity
power sources.
REPLACING THE TAPS AND THERMOSTAT
Proceed in the following way when replacing a tap or the thermostat:
• Remove pan supports, burner heads.
• Unscrew the burner fixing screws (Vc) (fig. 36).(four for ultrarapid burner and two for the other burners)
• Remove the hob, unscrewing rear fixing screws (Vs) (fig. 36) which lock the hob at the supports (S).
• Pull out the knobs.
• Unscrew the three fixing screws (Vf) (fig. 36) which lock the front panel to the front frame then slip out from the
upper fixing brackets.
• Unscrew the six fixing screws (Vp) (fig. 36) which lock the side profiles and remove it.
• Unscrew the two fixing screws (Vd) (fig. 36 which lock the hob at the back and remove it.
• Unscrew the nuts (D) of the gas aluminium pipes a nd pull out the thermocouple quick connectors (F) (fig.33).
• Unscrew the screws (Vt) (fig. 32) which lock the crosspieces.l
• Unscrew the screws (Vb) (fig. 32) which unite the the bridles of the taps to the front frame.
• Make to slip the ramp toward the back part and unscrew the screws (Vb) (fig. 33) in order to free the taps.
• Change seal each time a tap or a thermostat is replaced. This will ensure perfect retention between the tap or
a thermostat and part.
• Reassemble all the parts following the same procedure but in the reverse order.
36
INSTRUCTIONS FOR THE INSTALLER