Campomatic DVD5030B - Manual (Page 30)

28
Troubleshooting
!
If there is any failure, please check as below. If you are not sure with the instructions or the problems still
can’t be solved, please contact your local distributor.
It isn’t the problem of the player in the following cases.
There is noise when the disc is rotating;
Image distortion occurs in the process of scanning.
Warning
In any case, it is prohibited to repair the player without authorization, or else the warranty is void. Do not
disassemble the shell to avoid electric shock.
Failure Reason and solution
No power supply Please make sure that the AC outlet has electricity.
Insert the AC power line firmly.
Press the Power key on the front panel to turn on the player.
Cut off the power supply and connect again, and then press
the Power key on the remote control to restart the player.
Auto standby The default setting of the player: in stopped state, if there is
no operation in 5 minutes, the player enables screen saver
automatically; if there is no operation in 10 minutes in screen
saver, the player enters standby automatically. You can press
the Power key on the remote control to restart the player, or
select “OFF” in “Main menu – General – System – Screen
saver”.
Remote control can’t work normally The remote control isn’t aimed at the receiver. Please aim the
remote control at the receiver on the front panel.
There is obstacle between the remote control and the player.
Please remove it.
Battery is too low. Please replace with new batteries.
Please refer to the instruction of “Using remote control”.
Can’t play discs Please make sure that the label of the disc is upwards. If the
disc is dirty, please clean first.
The disc is empty or can’t be played. Please check whether the
area code of the disc matches the player.
Red key appears on the screen Selected function or operation is unavailable in current state.
The reason may be:
1. Software function limit of certain BD/DVD discs.
2. Certain BD/DVD discs don’t support selected function.
3. The selected function is invalid in current mode.
Playing mode is different from the
setting
No HDMI output Check whether the HDMI connection between the player and
external device is loose, and insert properly if yes.
Check whether your TV supports 720p/1080i/1080p/1080p24
HDMI output resolution, and adjust the output resolution of the
Image is frozen and
operation is invalid
For certain discs, the settings in the menu are invalid. Please
operate according to the disc menu.