Campomatic Hobs Vetro V Series - Manual (Page 12)

12
Instructions for the user
7.2.8 Timer (on some models only)
Some models are equipped with a 1 to 99-minute cooking timer.
To use the timed cooking, first set the power level by following the instructions given in paragraphs
“7.2.2 Single Cooking Zones” and “7.2.3 Dual Cooking Zones”.
Now, with the hob NOT locked out (if it is locked out, press the “ ” key to enable the functions),
press the time symbol.
Between the symbols “＋”and“－”of the first active cooking zone, a LED light will turn on to indicate
that the minutes to be set will refer to operation of that particular zone.
The automatic operation minutes of the cooking zone can be increased or decreased by using the “＋”
and “－” keys beside.
After 5 seconds have gone by since the last time it is pressed, the timer will start and the cooking
zone will operate until the display above the time symbol reaches 0.
At this point the cooking zone will automatically turn off.
It is also possible to use the timed cooking function on more than cooking zone at the same time. Once
the timer is set on the first zone, press time key to shift the timer controls over to the next active zone
(the LED light between the symbols “ ＋” and “ －” of the second active cooking zone will be activated)
and then set the cooking duration as previously described.
When the timed cooking is active on several cooking zones at the same time, the display between
the symbols “ ＋ ” and “－” of the cooking zone will alternatively turn on and at the same time the
minutes display found on the time symbol will show the time remaining for the zone with the LED light on.
7.2.9 Modifying the data set
During timed cooking, each single pressure on the “＋” and “－”symbols increases or reduces the
power of the cooking zone.
To change the remaining time of a zone, you have to press time key until the LED light in the
cooking zone turns on. Now it will be possible to change the operating time by working with the
symbols “＋” and “－”of the timer.
7.2.10 Residual heat
Each cooking zone is equipped with a residual heat warning device. After any zone is switched off, a
flashing “ ”may appear on the display. This warns that the cooking zone concerned is still very hot.
Cooking can be restarted while the
is flashing; proceed as described in points “7.2.2 / 7.2.3”.
7.2.11 Control circuit board thermal protection
If the cooking zones cause overheating of the internal electronic circuit board, the heat will be switched
off automatically. This switches off power to the front zones, and the letters and flash alternately
on the power leds. If the circuit board does not cool down, power to all the cooking zones is switched off,
and the power leds display the text
. Cooking can be resumed once the temperature
has dropped below the safety threshold.
7.2.12 Operator Error
If the user makes a mistake when using the push-buttons, an appears on the power display; it will
remain there as long as the user continues to press the button being used incorrectly.
7.2.13 Switching off the cooking zones
The c o o k I n g z o n e s are s w I t c h e d o f f when the operational power display indicates 0. The zone w i I l
automatically deactivate 5 seconds after the display shows 0.
If the cooking zones are hot, the blinking residual heat “ ” will appear after they are switched off.