Campomatic WM950XE - Manual (Page 11)

Important!
• The door will be locked throughout the delay time. If you need to open the door, you must first set the
washing machine to PAUSE by pressing button5 and wait a few minutes before opening the door. After you
have closed the door, press the same button again.
Important! The Delay Start cannot be selected with the draining programme.
Altering an option or a running programme
It is possible to change some options before the programme carries them out..Before you make any change,
Changing a running programme is possible only
then to the new programme position. Start
The washing water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme which is running.
Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to OFF to cancel a programme which is running, and wait few minutes to open the
door (it is possible only if in the tub there is not water).
At the end of the programme
The machine stops automatically. The blinking zero appears on the display. If a programme or an option that
indicate that the water must be
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to OFF.
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the relevant button.
4. Press button 5.
At the end of the programme, the door is released, after few minutes, and can be opened. Turn the programme
selector dial to OFF to switch the machine off.
Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out
another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant
smells.
Stand-By:
1.Once the programme has finished after a few minutes and the energy saving system will be enabled. The
brightness of the display and the indicator pilot lights are off.
2.If the appliance is switch on button in PAUSE, only the brightness of the display is off.By pressing any button
11
Cancelling the Delay Start after having started the programme:
1. Set the washing machine to PAUSE by pressing button 5.
2. Press button 10 repeatedly until the display shows 0'.
3. Press button 5 again to start the programme.
you must pause the washing machine by pressing button 5.
by resetting it. Turn the programme selector dial to OFF and
the new programme by pressing button 5 again.
,the appliance will come out of the energy saving status.
that ends with water left in the tub has been selected, the door is locked to
emptied out before opening the door.