Campomatic WM950XE - Manual (Page 13)

1
2
Screw the inlet water pipe out.
Clean with the tool (like the gauze
brush and etc.)
Cleaning of the inlet water valve
If the inlet water time is found to be too long, please clean the filter net of the inlet valve.
13
If the machine has the emergency drainage
Rotate the programme selector dial to OFF(stop) position and to close the water tap. 1
If necessary, wait until the water has cooled down . 2
Place a container on the floor, pull out the emergency emptying hose, place it into the
container.Remove its cap and wait until the remaining water naturally flows out. 3
Emergency drainage pipe
Drainage pipe ferrule
If the machine has the emergency drainage, please follow the methods below when the
machine cannot work normally :
Open the filter's door Turn the emergency
drain hose cap Pull out the emergency
emptying hose Remove the cap
.
If the machine doesn’t have Emergency drainage, please follow the methods[1] above .
Cleaning of the filter of the drainage pump
Please clean the drainage pump regularly to prevent the sundries blocking the drainage pipe.
Close the water tap
Empty the water from the pump to a container cautiously .
Install the pump cover
1
4
Screw the pump cover out and clean the filter 5
6
Pump cover
If the machine cannot work normally or filter net of the drainage pump cannot
be cleaned, pleasefollow the methods[1] below :
2 Disconnect the power plug
If necessary,wait until the water 3 has cooled down