Campomatic WM950XE - Manual (Page 14)

14
Warning!
When the appliance is in use and depending on the programme selected there can be hot water in the pump.
Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle,
is securely retightened so as to stop leaks and young
If you wash rugs, it is compulsory to inspect and clean the filter.
Cleaning the water inlet filters
Important!
If the appliance doesn't fill, takes long to fill with water, the starting button blinks yellow or the display (if
available) shows the relevant alarm (see chapter «What to do if...» for more details), check if the water inlet
filters are blocked.
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose from the tap.
• Clean the filter in the hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the connection is tight.
• Unscrew the hose from the machine. Keep a rag nearby
because some water may flow.
• Clean the filter in the valve with a stiff brush or with the
• Screw the hose back to the machine and make sure the
• Turn on the water tap.
Frost precaution or emergency emptied out
If the machine is exposed to temperatures below 0°C or if the water is not discharged, proceed as follows.
1 Pull out the plug from the power socket.
2 Turn off the water tap.
3 Unscrew the inlet hose.
4 Place a bowl on the floor and place the end of the inlet and drain hoses into it. The water should drain by
gravity into the bowl.
and is empty. When replacing the cover, ensure it
children being able to remove it.
piece of cloth.
connection is tight.