Campomatic WM950XE - Manual (Page 15)

15
What to do if.....
Certain problems are due to lack of simple
maintenance or oversights, which can be solved
easily without calling out an engineer. Before contacting your local Service Centre, please
carry out the checks listed below.
Malfunction Possible Cause / Solution
The washing machine does not work
Close the washing machine's door.
Water leakage Correctly connect the inlet water pipe.
The spin of the clothes is abnormal Reload and distribute the laundry evenly in the drum.
There is the peculiar smell in the
shing machine wa-
Run a Self-clean cycle without any clothes.
No water is visible in the drum No fault-water is under the visible area.
There is the remaining water in the
softener's box
No fault- the effect of the softener will not be affected.
The remaining detergent is left on
the clothes
The washing machine does not fill
Turn on the water tap.
Check the selection of
. the procedure
Reconnect the water inlet pipe.
Check if the water pressure is sufficient.
Check if the inlet water pipe is bent or blocked.
Close the washing machine’s door.
The washing machine fills and drains
at the same time.
Make sure the end of the drainage pipe is higher
than the water level inside the machine .
Check if the drainage pipe and waste have been
sealed.
The washing machine does not drain
Check if the drainage pumps is blocked.
Check if the drainage pipe is bent or blocked.
Check the height of the drainage nozzle, make
sure it is 0.6-1 meter high from the bottom of the
washing machine.
Vibration of the washing machine
Level the washing machine.
Fasten the footing.
Check if all the delivery bolts have all been removed.
Press the <<S >>button. tart/Pause
The water-fast component of the non-phosphorus
detergent will be left on the clothes to form into spot.
Please select «Rinse&Spin» programme.
or brush away the fleck after the clothes is dried.