Caple CR9215 - Manual (Page 30)

Ignition of the oven burner
1) Open the oven door to the full
extent.
WARNING: Risk of explosion! The
oven door must be open during this
operation.
2) Lightly press and turn the temperature
knob anti-clockwise (fig. 6.3) to the max
position (
fig. 6.1).
3) Press the knob firmly until the burn-
er lights.
Never continue this operation for
more than 15 seconds. If the burner
has still not ignited, wait for about 1
minute prior to repeating the ignition.
In case of mains failure, press the
knob firmly and immediately put a lit
match or taper to the opening “F”
(fig. 6.4).
4) Wait about 10/15 seconds after the
burner lights before releasing the
knob (time to prime the valve).
5) Close the oven door slowly and
adjust the burner according to the
power required.
If the flame extinguishes for any reason,
the safety valve will automatically shut
off the gas supply to the burner.
To re-light the burner, first turn the oven
control knob to position “●”, wait for at
least 1 minute and then repeat the
lighting procedure.
Fig. 6.4
F
Fig. 6.3
30