Caple C240SS - Manual (Page 14)

14
0
F
I I I
I
I
I
II
I
I
I
I I I I
I
° C
P P
3
0
F
I I
I
I
I
I I I
I
I
I
I
HOW TO START THE PYROLYSIS CYCLE
Important: the pyrolysis cycle must only be performed with the oven empty; so,
before starting the cycle take all the accessories (shelves, drip tray, baking tray
and anti-grease filter) out of the oven cavity and dry any traces of overflowed
liquid.
Do not use any degreasing products (e.g. degreasing
sprays, detergents, etc.).
1.
Close the oven door (if it is open or not closed prop-
erly the pyrolysis cycle will not start).
2.
Turn the oven selector knob to the pyrolysis posi-
tion (P);
P0•00 appears on the electronic programmer
display with the letter P flashing.
3.
Press pushbutton 3 on the programmer to start the
cycle.
This combined confirmation operation offers greater
safety when there are children; in fact turning the knob
to the pyrolysis function has no effect if key 3 of the
programmer is not then pressed.
• P1•30 (pyrolysis time, 1 hour and 30 minutes) appears
and the door is locked;
• On the control panel the pilot light with the key lights
up to indicate that the door is locked.
4.
To increase the pyrolysis cycle time (max 3 hours)
press key 2 of the programmer then key 6. To go back-
wards to the minimum of 1 hour and 30 minutes press
key 2 then key 5.
• During the setting AUTO flashes and P disappears.
5.
The pyrolysis cycle starts immediately and is completed
in the programmed time.
• Throughout the pyrolysis cycle the programmer dis-
plays the time (hours and minutes) remaining until the
cycle is finished.
°
C
P P
2 5 6
I
I I I
I
I
I
II
I
I
➁
➂
➃
➄
VERY IMPORTANT:
The pyrolysis only starts with the oven door closed. If
the door is open or not closed properly the oven CAN-
NOT perform the pyrolysis; electronic safety devices
prevent the pyrolysis from starting.