Cleaning and maintenance – Caple C240SS User Manual

Page 33

Advertising
background image

29

GENERAL ADVICE

Important:
Before any operation of cleaning and maintenance disconnect the appliance from
the electrical supply.

It is advisable to clean when the appliance is cold and especially for cleaning the enam-
elled parts.

Avoid leaving alcaline or acidic substances (lemon juice, vinegar, etc.) on the surfaces.
Avoid using cleaning products with a chlorine or acidic base.
The oven must always be cleaned after every use, using suitable products and keeping
in mind that its operation for 30 minutes on the highest temperature eliminates most
grime reducing it to ashes.
Before starting the pyrolysis cycle do not spray any degreasing products or detergents
on the oven walls.

ENAMELLED PARTS

All the enamelled parts must be cleaned with a sponge and soapy water only or other
non-abrasive products.

Dry preferably with a chamois leather.

Do not use a steam cleaner because the moisture can get into the appliance
thus make it unsafe.

Do not store flammable material in the oven.

Cleaning and maintenance

4

CLEANING THE OVEN CAVITY

The oven has a specific “PYROLYSIS FUNCTION” which can clean the cavity by pul-
verising the residual cooking greases by high temperature.
Do not wait for the oven to be very greasy before performing this cleaning. It should
not be performed after every cooking, either, but only when the level of dirt justifies it
(on average 1 – 2 times a month depending on oven use).

To use this function see the specific chapters: “Selecting the functions – PYROLYSIS
FUNCTION”, “How to start the pyrolysis cycle”, “Problems in starting and during the
pyrolysis cycle”, “How to stop the pyrolysis cycle” and “What to do when the pyrolysis
cycle has finished”.

Take the drip tray, shelf and grease filter (if fitted) out of the oven. They can be washed
in the sink.

STAINLESS STEEL AND ALUMINIUM PARTS AND SILK-SCREEN PRINTED SURFACES

Clean using an appropriate product. Always dry thoroughly.

IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra-
sion. You are advised to use a soft cloth and neutral soap.

Advertising