Caple C240SS - Manual (Page 22)

PROGRAMMER
MESSAGE MESSAGE MEANING WHAT TO DO
Oven temperature sensor broken
or not working properly.
The cooling fan stays on in every
cooking function and if the pyroly-
sis cycle is in progress the door
stays locked.
Turn the function selector knob to
0. The 30 minute countdown will
start (see below).
Temperature sensor measurement
error during the Pyrolysis cycle.
This may be due to the Pyrolysis
cycle being stopped and started
again when it was quite a way
through.
Turn the oven selector knob to 0.
Wait for at least 15 minutes befo-
re repeating the operations to start
the Pyrolysis cycle.
If the message is still given after
several attempts call the After-
Sales Service.
I
I I I
I
I
I
II
I
I
30 F0 or 30 F1.
30’ countdown.
If the selector knob is turned and
then returned to 0 the count starts
again from 30.
Wait for the countdown to stop.
The fan stops and the door, if
locked, unlocks.
Unplug the oven and contact the
After-Sales Service because the
oven can no longer be used.
Programmer with display off.
Turn the function selector knob to
0, wait for the oven to cool down
completely, switch the electricity
off for a few seconds.
If after this procedure the display
is still off unplug the oven and con-
tact the After-Sales Service. The
oven must not be used.
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the ope-
rations to start the Pyrolysis cycle.
door with AUTO flashing and
audible signal. The oven door has
been opened for 5 minutes with
the Pyrolysis cycle in progress.
The Pyrolysis cycle is cancelled.
I
I I I
I
I
I
II
I
I
Close the oven door and repeat
the operations to start the
Pyrolysis cycle.
door with AUTO flashing. The
oven door has been opened with
the Pyrolysis cycle in progress.
The Pyrolysis cycle cancels.
I I I I I I I
I
I
I
I
I I I I I I I I I I I I
I
I
I
I
I I I I I
Close the oven door, press any
programmer key to switch off the
audible signal and repeat the ope-
rations to start the Pyrolysis cycle.
door flashing and audible signal.
The function selector knob has
been turned to the pyrolysis func-
tion for 5 minutes with the oven
door open.
I I I I I I I I
I
I
I
I
I I I I I I I I I I I I I
I
I
I
I I
I I I I
I
I I I
I
I
I
II
I
I
Close the oven door and repeat
the operations to start the
Pyrolysis cycle. door. The oven function selector
knob has been turned to the pyrolysis
function with the oven door open.