Cata HGR 110 AS WH - Manual (Page 38)

Door type B
Open the door fully to position “D”
Lift the two mobile links “A” of the hinges, until fixing at
point “B”.
Then close the door to the half-way position.
Next, lift the door upwards and remove it, sliding it out-
wards; hold the door by the sides close to the hinges when
doing this.
To replace the door, first slide the hinges into their grooves
and open the door completely.
Remember to turn the two moving links “B” used to engage
the two hinges before closing the door (Fig. X).
A
B
D
WARNING
• Take care not to remove the hinge locking system when
taking off the door, as the hinge mechanism can spring back
suddenly.
• Never submerge the door in water for any reason.
Door type C
Open the door and support it firmly.
Using a suitable screwdriver remove the lower hinge by the
part fixed to the oven.
Then remove the upper hinge from its place and take off
the door.
To replace the door, follow the same steps in reverse.
Oven accessories (Fig. 4)
The oven can be provided with lateral guides fitted to the
oven wall. Insert the grid and oven sheet provided on the
lateral guides. To remove the guides proceed as follows for
the two types:
Bars type 1
To remove the lateral guides press downwards at point A.
Bars type 2
To remove the lateral guides take out the screw using a sui-
table screwdriver, lift the bars upwards until they are free.
A
INSTRUCTIONS FOR INSTALLATION
This appliance must be installed by a competent person, in
accordance with the current version of the UK Safety Rules
and Regulations or their European equivalent:
Urban development regulations (published by the De-
partment of Environment).
Urban development laws (published by the Scottish Execu-
tive Development Department).
IEE wiring regulations.
Electricity in labour regulations.
PRIOR START-UP OF THE APPLIANCE
When it is unpacked, check that the following parts are with
the oven:
• Instructions and Installation Manual
• oven grid
• 1 tray
• Screws and stoppers for fitting the appliance in the hou-
sing